ENGINE IMMOBILISER SYSTEM (for Sedan) > Security Indicator Light Circuit |

| 1.PERFORM ACTIVE TEST USING TECHSTREAM |
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the tester on.
Enter the following menus: Body Electrical / Immobiliser / Active Test.
Perform the Active Test according to the display on the tester.
| Tester Display | Test Part | Control Range | Diagnostic Note |
| Security Indic | Turn security indicator ON/OFF | ON/OFF | - |
|
| ||||
| NG | |
| 2.CHECK HARNESS AND CONNECTOR (TRANSPONDER KEY ECU - SECURITY INDICATOR LIGHT) |
![]() |
Disconnect the D23 transponder key ECU connector.
Disconnect the D25 security indicator connector.
Measure the resistance.
| Tester Condition | Specified Condition |
| D23-8 (IND) - D25-2 | Below 1Ω |
| D23-8 (IND) - Body ground | 10 kΩor higher |
Reconnect the D23 transponder key ECU connector.
Reconnect the D25 security indicator connector.
|
| ||||
| OK | |
| 3.INSPECT TRANSPONDER KEY ECU ASSEMBLY |
![]() |
Measure the voltage.
| Tester Condition | Condition | Specified Condition |
| D23-8 (IND) - Body ground | Immobiliser set | 11 to 14 V and below 1 V output alternately |
|
| ||||
| OK | ||
| ||