Home › Drivetrain ยท U340E AUTOMATIC TRANSMISSION / TRANSAXLE › SPEED SENSOR (for Hatchback)

SPEED SENSOR (for Hatchback) > INSTALLATION



1. INSTALL TRANSMISSION REVOLUTION SENSOR
  1. Coat a new O-ring with Toyota Genuine ATF WS and install it to the transmission revolution sensor.

  1. Install the transmission revolution sensor to the automatic transaxle assembly with the bolt.

    Torque:
    7.8 N*m{ 80 kgf*cm , 69 in.*lbf }

  1. Connect the transmission revolution sensor connector.



2. INSTALL BATTERY CARRIER
  1. Install the battery carrier with the 5 bolts.

    Torque:
    17 N*m{ 173 kgf*cm , 13 ft.*lbf }

  1. Engage the 6 clamps and connect the wire harness to the battery carrier.



3. INSTALL BATTERY TRAY


4. INSTALL BATTERY
  1. Install the battery onto the battery tray with the battery clamp.

    Torque:
    3.5 N*m{ 36 kgf*cm , 31 in.*lbf }

  1. Connect the cable to the battery terminal.

    Torque:
    5.4 N*m{ 55 kgf*cm , 48 in.*lbf }



5. INSPECT FOR AUTOMATIC TRANSAXLE FLUID LEAK