Home › Drivetrain · U340E AUTOMATIC TRANSMISSION / TRANSAXLE › SPEED SENSOR (for Sedan)

SPEED SENSOR (for Sedan) > INSPECTION



1. INSPECT SPEED SENSOR


    C113863E19
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    1 - 2
    20°C (68°F)
    560 to 680 Ω

    If the result is not as specified, replace the speed sensor.



2. INSPECT SPEEDOMETER SENSOR


C117095E01
  1. Connect the positive (+) lead from the battery to terminal 1 and the negative (-) lead to terminal 2.

  1. Connect the positive (+) lead from the tester to terminal 3 and the negative (-) lead to terminal 2.

  1. Rotate the shaft.

  1. Check that the voltage output varies between 0 V and 11 V between terminals 2 and 3.

    HINT:
    The voltage output oscillates more than 4 times every revolution of the speedometer sensor shaft.
    If the operation is not as specified, replace the speedometer sensor.