PARK / NEUTRAL POSITION SWITCH (for Hatchback) > REMOVAL |
| 1. REMOVE ENGINE UNDER COVER LH |
| 2. SEPARATE TRANSMISSION CONTROL CABLE ASSEMBLY |
![]() |
Remove the nut and disconnect the transmission control cable assembly from the control shaft lever.
Remove the clip and separate the transmission control cable assembly from the No. 1 transmission control cable bracket.
| 3. REMOVE PARK/NEUTRAL POSITION SWITCH ASSEMBLY |
Disconnect the connector from the park/neutral position switch assembly.
![]() |
Remove the nut, washer and the control shaft lever.
![]() |
Pry out the lock plate and remove the nut, lock plate and washer.
![]() |
Remove the 2 bolts and pull out the park/neutral position switch assembly from the automatic transaxle assembly.