VALVE BODY ASSEMBLY (for Sedan) > REMOVAL |
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 2. REMOVE ENGINE UNDER COVER LH |
| 3. DRAIN AUTOMATIC TRANSAXLE FLUID |
Remove the drain plug and gasket, and drain ATF.
Install a new gasket and the drain plug.
| 4. REMOVE AUTOMATIC TRANSAXLE OIL PAN SUB-ASSEMBLY |
![]() |
Remove the 19 bolts and remove the oil pan and oil pan gasket.
![]() |
Remove the 2 magnets from the oil pan.
![]() |
Examine the particles in the pan.
Collect any steel chips using the removed magnets.
Carefully inspect the foreign matter and particles in the pan and on the magnets to guess at the type of wear which might be found in the transaxle.
Steel (magnetic): bearing, gear and clutch plate wear
Brass (non-magnetic): bearing wear
| 5. REMOVE VALVE BODY OIL STRAINER ASSEMBLY |
![]() |
Remove the 3 bolts and remove the oil strainer.
![]() |
Remove the oil strainer gasket from the oil strainer.
| 6. REMOVE TRANSMISSION VALVE BODY ASSEMBLY |
![]() |
Disconnect the 5 connectors.
Remove the bolt and lock plate and remove the ATF temperature sensor.
![]() |
Remove the 2 bolts and remove the detent spring cover and detent spring.
![]() |
Remove the 13 bolts and remove the valve body assembly.
![]() |
Remove the check ball body and check ball body spring.
![]() |
Remove the 2 apply gaskets.