Home › Drivetrain ยท U340E AUTOMATIC TRANSMISSION / TRANSAXLE › TRANSMISSION CONTROL CABLE (for Hatchback)

TRANSMISSION CONTROL CABLE (for Hatchback) > REMOVAL



1. REMOVE REAR CONSOLE BOX ASSEMBLY
(Click here)


2. DISCONNECT TRANSMISSION CONTROL CABLE ASSEMBLY


    C244553
  1. Disconnect the end of the transmission control cable assembly from the shift lever assembly.



    C271864E01
  1. Rotate the nut of the transmission control cable assembly approximately 180° in the direction shown in the illustration, and while holding the nut, separate the transmission control cable assembly from the shift lever assembly.
    Text in Illustration 
    *1
    Nut
    *a
    Rotate approximately 180°
    *b
    Pull out

    NOTICE:
    Rotating the nut too much will damage the internal spring, and the transmission control cable assembly will not be reusable. Do not turn the nut too far.



3. REMOVE BATTERY


    A248909
  1. Disconnect the cable from the battery terminal.

  1. Loosen the 2 nuts and remove the battery clamp.

  1. Remove the battery.



4. REMOVE BATTERY TRAY


5. REMOVE BATTERY CARRIER


    A259809
  1. Disengage the 6 clamps and disconnect the wire harness from the battery carrier.

  1. Remove the 5 bolts and the battery carrier.



6. REMOVE AIR CLEANER ASSEMBLY


    A249575
  1. Disengage the clamp and disconnect the fuel vapor feed hose assembly from the No. 1 air cleaner hose.

  1. Loosen the 2 hose clamps and disconnect the fuel vapor feed hose assembly from the No. 1 air cleaner hose and vacuum switching valve assembly.



    A249576
  1. Disconnect the No. 2 fuel vapor feed hose from the intake manifold.



    A249577
  1. Disengage the 2 clamps and disconnect the wire harness from the air cleaner cap sub-assembly and vacuum switching valve assembly.

  1. Disconnect the mass air flow meter connector.

  1. Disconnect the vacuum switching valve connector.



    A249578
  1. Loosen the hose clamp and disconnect the No. 1 air cleaner hose from the throttle with motor body assembly.

  1. Disengage the 2 clamps and remove the air cleaner cap sub-assembly with No. 1 air cleaner hose.



    A246503
  1. Remove the air cleaner element.



    A249653
  1. Disengage the clamp and disconnect the wire harness from the air cleaner case.

  1. Remove the 2 bolts and the air cleaner case from the air cleaner bracket.



7. REMOVE AIR CLEANER BRACKET


    A248643
  1. Disengage the clamp and disconnect the wire harness from the air cleaner bracket.

  1. Remove the 2 bolts and the air cleaner bracket.



8. REMOVE FRONT EXHAUST PIPE ASSEMBLY
(Click here)


9. REMOVE FRONT NO. 1 FLOOR HEAT INSULATOR


C235679
  1. Remove the 2 bolts, nut and the front No. 1 floor heat insulator.



10. REMOVE TRANSMISSION CONTROL CABLE ASSEMBLY


    C117118
  1. Separate the transmission control cable assembly from the control cable support.



    C117100
  1. Remove the nut and disconnect the transmission control cable assembly from the control shaft lever.

  1. Remove the clip and separate the transmission control cable assembly from the No. 1 transmission control cable bracket.



    C244630
  1. Remove the 3 nuts and the transmission control cable assembly.