Home › Drivetrain ยท U340E AUTOMATIC TRANSMISSION / TRANSAXLE › SHIFT LEVER (for Sedan)

SHIFT LEVER (for Sedan) > REMOVAL



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL


2. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY
  1. Remove the shift lever knob sub-assembly from the shift lever.



3. REMOVE CENTER LOWER INSTRUMENT PANEL FINISH PANEL


B132316
  1. Disengage the 2 claws and 2 clips and remove the instrument panel finish panel lower center.



4. REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY


B132347
  1. Shift the shift lever into the N position.

  1. Disengage the 5 clips and the claw and remove the upper console panel.



5. REMOVE REAR UPPER CONSOLE PANEL SUB-ASSEMBLY


B132348
  1. Disengage the 3 clips and 3 claws.

  1. Disconnect the connector and remove the rear upper console panel.



6. REMOVE CONSOLE BOX CARPET


    B132346
  1. Remove the console box carpet.



7. REMOVE REAR CONSOLE BOX ASSEMBLY


    B132349
  1. Disconnect the clamp.

  1. Remove the 2 bolts and 2 screws.

  1. Disengage the 4 claws and remove the rear console box.



8. SEPARATE TRANSMISSION CONTROL CABLE ASSEMBLY


C117115
  1. Disconnect the control cable from the shift lever.



    C117114E01
  1. Turn the nut and separate the control cable from the shift lever retainer.



9. REMOVE FLOOR SHIFT ASSEMBLY
  1. Separate the shift lock control computer connector and indicator wire connector.

  1. Separate the 2 wire harness clamps from the shift lever.



    C118483
  1. Remove the 4 bolts and remove the shift lever.