SHIFT LEVER (for Hatchback) > DISASSEMBLY |
| 1. REMOVE UPPER POSITION INDICATOR HOUSING |
![]() |
Disengage the 4 claws and remove the upper position indicator housing from the shift lock control unit assembly.
| 2. REMOVE SHIFT LOCK RELEASE BUTTON COVER |
![]() |
Disengage the 2 claws and remove the shift lock release button cover from the upper position indicator housing.
| 3. REMOVE CONTROL POSITION INDICATOR PLATE |
![]() |
Disengage the claw and remove the control position indicator plate from the upper position indicator housing.
| 4. REMOVE INDICATOR LIGHT WIRE SUB-ASSEMBLY |
![]() |
Turn the indicator light wire sub-assembly counterclockwise and separate it from the position indicator light guide.
![]() |
Disengage the wire harness clamp and separate the transmission control switch connector from the shift lock control unit assembly.
| *1 | Transmission Control Switch Connector |
Disengage the 3 clamps and separate the indicator light wire sub-assembly from the shift lock control unit assembly.
![]() |
Using a screwdriver, disengage the claw and remove the wire harness clamp from the transmission control switch connector.
![]() |
Using a precision screwdriver, lift up the terminal retainer of the transmission control switch connector to release the lock.
![]() |
Using a precision screwdriver, pull out the indicator light wire sub-assembly from terminals 7 and 14 of the transmission control switch connector.
| *a | Front view of transmission control switch connector |
| 5. REMOVE POSITION INDICATOR LIGHT BULB |
Remove the position indicator light bulb from the indicator light wire sub-assembly.
| 6. REMOVE POSITION INDICATOR LIGHT CAP |
Remove the position indicator light cap from the position indicator light bulb.
| 7. REMOVE POSITION INDICATOR LIGHT GUIDE |
![]() |
Disengage the 4 claws and remove the position indicator light guide from the shift lock control unit assembly.
| 8. REMOVE POSITION INDICATOR SLIDE COVER |
![]() |
Remove the position indicator slide cover from the shift lock control unit assembly.
| 9. REMOVE NO. 2 POSITION INDICATOR SLIDE COVER |
![]() |
Align the cutouts on the shank of the No. 2 position indicator slide cover and the position indicator slide cover, and remove the No. 2 position indicator slide cover from the position indicator slide cover.
| 10. REMOVE LOWER POSITION INDICATOR HOUSING |
![]() |
Using a screwdriver, disengage the 4 claws and remove the lower position indicator housing from the shift lock control unit assembly.