Home › Drivetrain ยท U340E AUTOMATIC TRANSMISSION / TRANSAXLE › SHIFT LEVER (for Hatchback)

SHIFT LEVER (for Hatchback) > REASSEMBLY



1. INSTALL LOWER POSITION INDICATOR HOUSING


    C244575
  1. Engage the 4 claws and install the lower position indicator housing to the shift lock control unit assembly.



2. INSTALL NO. 2 POSITION INDICATOR SLIDE COVER


    C235350
  1. Align the cutouts on the shank of the No. 2 position indicator slide cover and the position indicator slide cover, and install the No. 2 position indicator slide cover to the position indicator slide cover.



3. INSTALL POSITION INDICATOR SLIDE COVER


    C244568E01
  1. Install the position indicator slide cover to the shift lock control unit assembly.
    Text in Illustration 
    *a
    Arrow

    NOTICE:
    Install the position indicator slide cover so that its arrow mark points to the front of the vehicle.



4. INSTALL POSITION INDICATOR LIGHT GUIDE


    C244567
  1. Engage the 4 claws and install the position indicator light guide to the shift lock control unit assembly.



5. INSTALL POSITION INDICATOR LIGHT CAP
  1. Install the position indicator light cap to the position indicator light bulb.



6. INSTALL POSITION INDICATOR LIGHT BULB
  1. Install the position indicator light bulb to the indicator light wire sub-assembly.



7. INSTALL INDICATOR LIGHT WIRE SUB-ASSEMBLY


    C155838E02
  1. Insert the indicator light wire sub-assembly into terminals 7 and 14 of the transmission control switch connector.
    Text in Illustration 
    *a
    Front view of transmission control switch connector



    C236990
  1. Push down the terminal retainer of the transmission control switch connector to lock it.



    C272439
  1. Engage the claw and install the wire harness clamp to the transmission control switch connector.



    C244570E01
  1. Engage the 3 clamps and install the indicator light wire sub-assembly to the shift lock control unit assembly.
    Text in Illustration 
    *1
    Transmission Control Switch Connector

  1. Engage the wire harness clamp and install the transmission control switch connector to the shift lock control unit assembly.



    C244593
  1. Turn the indicator light wire sub-assembly clockwise and install it to the position indicator light guide.



8. INSTALL CONTROL POSITION INDICATOR PLATE


    C244566
  1. Engage the claw and install the control position indicator plate to the upper position indicator housing.



9. INSTALL SHIFT LOCK RELEASE BUTTON COVER


    C244565
  1. Engage the 2 claws and install the shift lock release button cover to the upper position indicator housing.



10. INSTALL UPPER POSITION INDICATOR HOUSING


    C244563
  1. Engage the 4 claws and install the upper position indicator housing to the shift lock control unit assembly.

    NOTICE:
    Securely engage the 4 claws.