TORQUE CONVERTER CLUTCH AND DRIVE PLATE (for Sedan) > INSPECTION |
| 1. INSPECT TORQUE CONVERTER CLUTCH ASSEMBLY |
![]() |
Inspect the one-way clutch.
Install SST so that it fits into notch of the converter hub and the notch of the outer race of the one-way clutch.
Press on the serrations of the stator with a finger and rotate it.
Check that it rotates smoothly when turned clockwise and locks up when turned counterclockwise.
![]() |
Check the condition of the torque converter clutch assembly.
If the inspection result of the torque converter clutch assembly meets any of the cases mentioned below, replace the torque converter clutch.
Replace the ATF in the torque converter clutch.
If the ATF is discolored and/or has a foul odor, completely stir the ATF in the torque converter clutch and drain it with the installation surface facing up.
Clean and check the oil cooler and oil pipe line.
![]() |
If the torque converter clutch is inspected or the ATF is changed, clean the oil cooler and oil pipe line.
![]() |
If the ATF is cloudy, inspect the oil cooler (radiator).
| 2. INSPECT DRIVE PLATE AND RING GEAR |
![]() |
Inspect the drive plate.
Set up a dial indicator and measure the runout of the 6 positions around the torque converter fitting surface.
Inspect the ring gear.
Inspect the ring gear for damage.
If the ring gear is damaged, replace the drive plate and ring gear.