OIL PUMP (for Sedan) > INSPECTION |
| 1. INSPECT STATOR SHAFT ASSEMBLY |
![]() |
Using a dial indicator, measure the inside diameter of the stator shaft bushings.
![]() |
Install the input shaft assembly onto the stator shaft assembly and check that the input shaft assembly turns smoothly.
| 2. INSPECT OIL PUMP GEAR CLEARANCE |
![]() |
Measure the clearance between the tips of the driven gear teeth and the drive gear teeth.
![]() |
Push the driven gear to one side of the body. Using a feeler gauge, measure the clearance.
![]() |
Using a straightedge and feeler gauge, measure the side clearance of both gears.
| No. | Thickness mm (in.) |
| 1 | 9.44 to 9.45 (0.3709 to 0.3713) |
| 2 | 9.45 to 9.46 (0.3713 to 0.3717) |
| 3 | 9.46 to 9.47 (0.3717 to 0.3721) |
| 4 | 9.47 to 9.48 (0.3721 to 0.3725) |
| 5 | 9.48 to 9.49 (0.3725 to 0.3729) |
| No. | Thickness mm (in.) |
| 1 | 9.44 to 9.45 (0.3709 to 0.3713) |
| 2 | 9.45 to 9.46 (0.3713 to 0.3717) |
| 3 | 9.46 to 9.47 (0.3717 to 0.3721) |
| 4 | 9.47 to 9.48 (0.3721 to 0.3725) |
| 5 | 9.48 to 9.49 (0.3725 to 0.3729) |
| 3. INSPECT FRONT OIL PUMP BODY SUB-ASSEMBLY |
![]() |
Using a dial indicator, measure the inside diameter of the oil pump body bushing.