OIL PUMP (for Hatchback) > INSPECTION |
| 1. INSPECT STATOR SHAFT ASSEMBLY |
![]() |
Using a caliper gauge, measure the inside diameter of the stator shaft bushings.
![]() |
Install the input shaft assembly onto the stator shaft assembly and check that the input shaft assembly turns smoothly.
| 2. INSPECT OIL PUMP GEAR CLEARANCE |
![]() |
Measure the clearance between the tips of the front oil pump driven gear teeth and the front oil pump drive gear teeth.
![]() |
Push the front oil pump driven gear to one side of the body. Using a feeler gauge, measure the clearance.
![]() |
Using a steel straightedge and feeler gauge, measure the side clearance of both gears.
| Part No. | Mark | Thickness mm (in.) |
| 35321-52060 | 1 | 9.44 to 9.45 (0.3709 to 0.3713) |
| 35321-52070 | 2 | 9.45 to 9.46 (0.3713 to 0.3717) |
| 35321-52080 | 3 | 9.46 to 9.47 (0.3717 to 0.3721) |
| 35321-52090 | 4 | 9.47 to 9.48 (0.3721 to 0.3725) |
| 35321-52100 | 5 | 9.48 to 9.49 (0.3725 to 0.3729) |
| Part No. | Mark | Thickness mm (in.) |
| 35322-52060 | 1 | 9.44 to 9.45 (0.3709 to 0.3713) |
| 35322-52070 | 2 | 9.45 to 9.46 (0.3713 to 0.3717) |
| 35322-52080 | 3 | 9.46 to 9.47 (0.3717 to 0.3721) |
| 35322-52090 | 4 | 9.47 to 9.48 (0.3721 to 0.3725) |
| 35322-52100 | 5 | 9.48 to 9.49 (0.3725 to 0.3729) |
| 3. INSPECT FRONT OIL PUMP BODY SUB-ASSEMBLY |
![]() |
Using a caliper gauge, measure the inside diameter of the front oil pump body bushing.