VALVE BODY ASSEMBLY (for Hatchback) > INSPECTION |
| 1. INSPECT SHIFT SOLENOID VALVE S1 |
![]() |
Measure the resistance according to the value(s) in the table below.
| *a | Component without harness connected (Shift Solenoid Valve S1) |
| Tester Connection | Condition | Specified Condition |
| Solenoid Connector (S1) - Solenoid Body (S1) | 20°C (68°F) | 11 to 15 Ω |
Connect the positive (+) battery lead to the terminal of the solenoid connector, and the negative (-) battery lead to the solenoid body, and check the operation of the shift solenoid valve.
| 2. INSPECT SHIFT SOLENOID VALVE S2 |
| 3. INSPECT SHIFT SOLENOID VALVE ST |
| 4. INSPECT SHIFT SOLENOID VALVE SLT |
![]() |
Measure the resistance according to the value(s) in the table below.
| *a | Component without harness connected (Shift Solenoid Valve SLT) |
| Tester Connection | Condition | Specified Condition |
| 1 - 2 | 20°C (68°F) | 5.0 to 5.6 Ω |
Connect the positive (+) battery lead with a 21 W bulb to terminal 2 and the negative (-) battery lead to terminal 1 of the solenoid valve connector, and check the operation of the valve.
| 5. INSPECT SHIFT SOLENOID VALVE SLU |