Home › Drivetrain ยท U340E AUTOMATIC TRANSMISSION / TRANSAXLE › DIFFERENTIAL CASE (for Sedan)

DIFFERENTIAL CASE (for Sedan) > DISASSEMBLY

for Preparation Click here



1. REMOVE FRONT DIFFERENTIAL CASE FRONT TAPERED ROLLER BEARING


C068434E03
  1. Using SST, remove the front differential case front tapered roller bearing from the differential case.

    SST
    09950-40011   (09951-04010, 09952-04010, 09953-04030, 09954-04010, 09955-04061, 09957-04010, 09958-04011)
    09950-60010   (09951-00390)



    C067940E03
  1. Using SST, remove the front differential case RH tapered roller bearing outer race from the transaxle housing.

    SST
    09387-00041   (09387-02020, 09387-02010)



2. REMOVE SPEEDOMETER DRIVE GEAR


    D025171
  1. Remove the speedometer drive gear from the differential case.



3. REMOVE FRONT DIFFERENTIAL CASE REAR TAPERED ROLLER BEARING


C067944E03
  1. Using SST, remove the front differential case tapered roller bearing from the differential case.

    SST
    09950-40011   (09951-04010, 09952-04010, 09953-04020, 09954-04010, 09955-04061, 09957-04010, 09958-04011)
    09950-60010   (09951-00430)



    C067943E03
  1. Using SST, remove the front differential case tapered roller bearing outer race from the transaxle case.

    SST
    09612-65014   (09612-01010)



4. REMOVE FRONT DIFFERENTIAL RING GEAR


D025172
  1. Place matchmarks on the front differential ring gear and differential case.



    D025173
  1. Using SST and a hammer, release the lock plate.

    SST
    09930-00010  



    C081314
  1. Remove the 8 bolts and the lock plate.



    C081315
  1. Using a plastic hammer, remove the front differential ring gear from the differential case.



5. REMOVE FRONT DIFFERENTIAL PINION SHAFT STRAIGHT PIN


C081316
  1. Using a punch and a hammer, release the differential case.



    C081317
  1. Using a pin punch and a hammer, remove the straight pin.



6. REMOVE FRONT NO. 1 DIFFERENTIAL PINION SHAFT


C081318
  1. Remove the pinion shaft from the front differential case.



7. REMOVE FRONT DIFFERENTIAL SIDE GEAR


C081319
  1. Remove the 2 pinions, 2 thrust washers, 2 side gears and 2 thrust washers No. 1 from the front differential case.