Home › Drivetrain ยท U340E AUTOMATIC TRANSMISSION / TRANSAXLE › DIFFERENTIAL CASE (for Hatchback)

DIFFERENTIAL CASE (for Hatchback) > DISASSEMBLY

for Preparation Click here



1. REMOVE FRONT DIFFERENTIAL CASE FRONT TAPERED ROLLER BEARING


    C162528E05
  1. Using SST, remove the front differential case front tapered roller bearing inner race from the differential case.
    Text in Illustration 
    *a
    Hold
    *b
    Turn

    SST
    09950-40011   (09951-04010, 09952-04010, 09953-04030, 09954-04010, 09955-04061, 09957-04010, 09958-04011)
    09950-60010   (09951-00390)



    C067940E07
  1. Using SST, remove the front differential case front tapered roller bearing outer race from the transaxle housing.
    Text in Illustration 
    *a
    Hold
    *b
    Turn

    SST
    09387-00041   (09387-02020, 09387-02010)



2. REMOVE FRONT DIFFERENTIAL CASE REAR TAPERED ROLLER BEARING


    C067944E05
  1. Using SST, remove the front differential case rear tapered roller bearing inner race from the differential case.
    Text in Illustration 
    *a
    Hold
    *b
    Turn

    SST
    09950-40011   (09951-04010, 09952-04010, 09953-04020, 09954-04010, 09955-04061, 09957-04010, 09958-04011)
    09950-60010   (09951-00430)



    C067943E05
  1. Using SST, remove the front differential case rear tapered roller bearing outer race and the front differential rear case shim from the transaxle case.
    Text in Illustration 
    *a
    Hold
    *b
    Turn

    SST
    09612-65014   (09612-01010)



3. REMOVE FRONT DIFFERENTIAL RING GEAR


    D025172E09
  1. Place matchmarks on the front differential ring gear and the differential case.
    Text in Illustration 
    *a
    Matchmark



    D025173E08
  1. Using SST and a hammer, release the ring gear lock plate.

    SST
    09930-00010  



    C081325E03
  1. Remove the 8 bolts and the 4 ring gear lock plates.



    C081315E01
  1. Using a plastic hammer, remove the front differential ring gear from the differential case.



4. REMOVE FRONT DIFFERENTIAL PINION SHAFT STRAIGHT PIN


    C081316E01
  1. Using a punch and hammer, release the staked part of the differential case hole.



    C081317E01
  1. Using a pin punch 5 mm and hammer, remove the front differential pinion shaft straight pin from the differential case.



5. REMOVE FRONT NO. 1 DIFFERENTIAL PINION SHAFT


    C081318E01
  1. Remove the front No. 1 differential pinion shaft from the differential case.



6. REMOVE DIFFERENTIAL GEAR KIT


    C081319E01
  1. Remove the differential gear kit (2 front differential pinions and 2 front differential side gears), 2 front differential side gear thrust washers and the 2 front differential pinion thrust washers from the differential case.