DIFFERENTIAL CASE (for Hatchback) > REASSEMBLY |
| 1. INSTALL DIFFERENTIAL GEAR KIT |
![]() |
After applying Toyota Genuine ATF WS to the differential gear kit (2 front differential pinions and 2 front differential side gears), 2 front differential side gear thrust washers and the 2 front differential pinion thrust washers, and install them to the front differential case.
| 2. INSTALL FRONT NO. 1 DIFFERENTIAL PINION SHAFT |
![]() |
Install the front No. 1 differential pinion shaft so as to align the straight pin holes in the front No. 1 differential pinion shaft and the differential case.
| 3. INSPECT DIFFERENTIAL SIDE GEAR BACKLASH |
![]() |
Measure the front differential side gear backlash while holding 1 pinion gear toward the case.
Referring to the table below, select front differential side gear thrust washers which will ensure that the backlash is within the specifications for both sides.
| Part No. | Thickness mm (in.) |
| 41361-17010 | 0.95 (0.0374) |
| 41361-17020 | 1.00 (0.0394) |
| 41361-17030 | 1.05 (0.0413) |
| 41361-17040 | 1.10 (0.0433) |
| 41361-17050 | 1.15 (0.0453) |
| 41361-17060 | 1.20 (0.0472) |
| 4. INSTALL FRONT DIFFERENTIAL PINION SHAFT STRAIGHT PIN |
![]() |
Using a pin punch 5 mm and hammer, install the front differential pinion shaft straight pin to the differential case.
![]() |
Using a chisel and hammer, stake the differential case hole.
| 5. INSTALL FRONT DIFFERENTIAL RING GEAR |
![]() |
Clean the contact surface of the differential case and the front differential ring gear.
Using ATF and a heater, heat the front differential ring gear to 90 to 110°C (194 to 230°F).
![]() |
After moisture on the front differential ring gear has completely evaporated, align the matchmarks on the front differential ring gear and the differential case, and quickly install them.
| *a | Matchmark |
![]() |
Install 4 new ring gear lock plates with the 8 bolts.
![]() |
Using SST, stake the 4 ring gear lock plates.
| 6. INSTALL FRONT DIFFERENTIAL CASE REAR TAPERED ROLLER BEARING |
![]() |
Using SST and a press, install the front differential case rear tapered roller bearing inner race to the differential case.
![]() |
Using SST and a press, install the front differential rear case shim and the front differential case rear tapered roller bearing outer race to the transaxle case.
| 7. INSTALL FRONT DIFFERENTIAL CASE FRONT TAPERED ROLLER BEARING |
![]() |
Using SST and a press, install the front differential case front tapered roller bearing inner race to the differential case.
![]() |
Using SST and a press, install the front differential case front tapered roller bearing outer race to the transaxle housing.