LUGGAGE DOOR HINGE TORSION BAR (for Sedan) > INSTALLATION |
| 1. INSTALL LUGGAGE DOOR HINGE TORSION BAR RH |
Check the identification mark on the luggage door hinge torsion bar RH.
![]() |
Connect the left end of the luggage door hinge torsion bar RH to the vehicle body as shown in the illustration.
![]() |
Using SST, connect the right end of the luggage door hinge torsion bar RH to install it on the vehicle body as shown in the illustration.
Connect the luggage door hinge torsion bar RH to the luggage compartment door torsion bar support.
| 2. INSTALL LUGGAGE DOOR HINGE TORSION BAR LH |
Check the identification mark on the luggage door hinge torsion bar LH.
Use the same procedure as for the RH side.