INPUT SHAFT (for Sedan) > INSPECTION |
| 1. INSPECT INPUT SHAFT |
![]() |
Using a dial gauge, check the input shaft runout.
![]() |
Using a micrometer, measure the outer diameter of the input shaft journal surface, at the locations indicated.
| 2. INSPECT 4TH GEAR |
![]() |
Using a cylinder gauge, measure the inside diameter of the 4th gear.
| 3. INSPECT 3RD GEAR |
![]() |
Using a cylinder gauge, measure the inside diameter of the 3rd gear.
| 4. INSPECT 4TH GEAR SYNCHRONIZER RING |
![]() |
Check for wear and damage.
Coat the 4th gear cone with gear oil.
Turn the synchronizer ring in one direction while pushing it against the 4th gear cone.
Check that the ring locks.
If the synchronizer outer ring does not lock, replace the synchronizer ring.
![]() |
Using a feeler gauge, measure the clearance between the synchronizer ring back and the gear spline end.
| 5. INSPECT 3RD GEAR SYNCHRONIZER RING |
![]() |
Check for wear and damage.
Coat the 3rd gear cone with gear oil.
Turn the synchronizer ring in one direction while pushing it against the 3rd gear cone.
Check that the ring locks.
If the synchronizer outer ring does not lock, replace the synchronizer ring.
![]() |
Using a feeler gauge, measure the clearance between the synchronizer ring back and the gear spline end.
| 6. INSPECT TRANSMISSION HUB SLEEVE NO.2 |
![]() |
Check the sliding condition between transmission hub sleeve No. 2 and transmission clutch hub No. 2.
Check that the edges of the transmission hub sleeve No. 2 spline gear are not worn down.
![]() |
Using a vernier caliper, measure the width of the transmission hub sleeve No. 2 groove (B) and the thickness of the claw part on gear shift fork No. 2 (A), and calculate the clearance.