Home › Drivetrain ยท C50 MANUAL TRANSMISSION / TRANSAXLE › DIFFERENTIAL CASE (for Sedan)

DIFFERENTIAL CASE (for Sedan) > INSPECTION



1. INSPECT FRONT DIFFERENTIAL PINION THRUST WASHER


C068517
  1. Using a micrometer, measure the thickness of the front differential pinion thrust washer.

    Minimum thickness:
    0.94 mm (0.0370 in.)

    If the thickness is less than the minimum, replace the front differential pinion thrust washer.



2. INSPECT FRONT DIFFERENTIAL PINION SHAFT NO.1


C068518
  1. Using a micrometer, measure the outer diameter of front differential pinion shaft No. 1.

    Minimum outer diameter:
    16.982 mm (0.6685 in.)

    If the outer diameter is less than the minimum, replace front differential pinion shaft No. 1.