Home › Drivetrain · C50 MANUAL TRANSMISSION / TRANSAXLE › DIFFERENTIAL CASE (for Sedan)

DIFFERENTIAL CASE (for Sedan) > DISASSEMBLY



1. REMOVE SPEEDOMETER DRIVE GEAR


C067982
  1. Remove the speedometer drive gear from the front differential case.



2. REMOVE FRONT DIFFERENTIAL RING GEAR


D032380E01
  1. Place matchmarks on the front differential ring gear and the front differential case.

  1. Remove the 8 bolts.



    C067984
  1. Using a plastic hammer, remove the front differential ring gear from the front differential case.



3. INSPECT FRONT DIFFERENTIAL SIDE GEAR BACKLASH


C067989
  1. Fix the front differential pinion to the front differential case side. Using a dial indicator, measure the front differential side gear backlash.

    Standard backlash:
    0.05 to 0.20 mm (0.0020 to 0.0079 in.)

    If the backlash is outside the specifications, replace the side gear thrust washers.



4. REMOVE FRONT DIFFERENTIAL PINION SHAFT STRAIGHT PIN


C067985
  1. Using a chisel and a hammer, loosen the staked part of the front differential case.



    C067986
  1. Using a pin punch (φ3 mm) and a hammer, remove the front differential pinion shaft straight pin from the front differential case.



5. REMOVE FRONT DIFFERENTIAL PINION SHAFT NO.1


C067987
  1. Remove front differential pinion shaft No. 1 from the front differential case.



6. REMOVE FRONT DIFFERENTIAL SIDE GEAR


C067988
  1. Remove the 2 front differential pinions, 2 front differential pinion thrust washers, 2 front differential side gear thrust washers No. 1 and 2 front differential side gears from the front differential case.

    HINT:
    Revolving the front differential pinion, remove the 2 pinions and 2 side gears.