DIFFERENTIAL CASE (for Hatchback) > REASSEMBLY |
| 1. INSTALL FRONT DIFFERENTIAL SIDE GEAR |
![]() |
Coat the sliding and rotating surfaces of the front differential side gear with gear oil.
Install the 2 front No. 1 differential side gear thrust washers onto the 2 front differential side gears.
Install the 2 front differential side gears, 2 front differential pinions and 2 front differential pinion thrust washers onto the front differential case.
| 2. INSTALL FRONT NO. 1 DIFFERENTIAL PINION SHAFT |
![]() |
Coat the front No. 1 differential pinion shaft with MP grease.
Install the front No. 1 differential pinion shaft onto the front differential case so that the hole for the front differential pinion shaft straight pin is aligned with the hole in the front differential case.
| 3. ADJUST FRONT DIFFERENTIAL SIDE GEAR BACKLASH |
![]() |
Fix the front differential pinion to the front differential case side. Using a dial indicator, measure the front differential side gear backlash.
| Parts No. | Thickness mm (in.) |
| 41361-22140 | 0.95 (0.0374 in.) |
| 41361-22020 | 1.00 (0.0394 in.) |
| 41361-22150 | 1.05 (0.0413 in.) |
| 41361-22030 | 1.10 (0.0433 in.) |
| 41361-22160 | 1.15 (0.0453 in.) |
| 41361-22040 | 1.20 (0.0472 in.) |
| 4. INSTALL FRONT DIFFERENTIAL PINION SHAFT STRAIGHT PIN |
![]() |
Using a pin punch (φ3 mm) and a hammer, install the front differential pinion shaft straight pin onto the front differential case.
![]() |
Using a chisel and a hammer, stake the front differential case hole.
| 5. INSTALL FRONT DIFFERENTIAL RING GEAR |
Clean the contact surfaces of the front differential case and front differential ring gear.
![]() |
Using a heater, heat the front differential ring gear to 90 to 110°C (194.0 to 230.0°F).
| *a | 90 to 110°C (194.0 to 230.0°F) |
After the moisture on the front differential ring gear has completely evaporated, quickly install the front differential ring gear onto the differential case.
![]() |
Aligning the 2 matchmarks, quickly install the front differential ring gear onto the front differential case.
| *a | Matchmark |
Install the 8 bolts.
| 6. INSTALL SPEEDOMETER DRIVE GEAR |
![]() |
Install the speedometer drive gear onto the front differential case.