Home › Drivetrain · C50 MANUAL TRANSMISSION / TRANSAXLE › SHIFT AND SELECT LEVER SHAFT (for Sedan)

SHIFT AND SELECT LEVER SHAFT (for Sedan) > DISASSEMBLY



1. REMOVE SELECT SPRING SEAT NO.2


C120733
  1. Using a screwdriver, remove the select spring No. 2 seat E-ring, select spring seat No. 2 and select return compression spring No. 2 from the shift and select lever shaft.



2. REMOVE SHIFT LEVER INNER NO.2


C120734
  1. Using a pin punch (φ5 mm) and a hammer, remove the shift inner lever slotted spring pin and shift lever inner No. 2 from the shift and select lever shaft.

    HINT:
    Check the orientation of shift lever inner No. 2.



3. REMOVE SHIFT LEVER INNER NO.1


C121093
  1. Using a pin punch (φ5 mm) and a hammer, remove the shift inner lever slotted spring pin, shift lever inner No. 1 and shift inter lock plate from the shift and select lever shaft.

    HINT:
    Check the orientation of shift lever inner No. 1.



4. REMOVE SELECT INNER LEVER


C120736
  1. Using a pin punch (φ5 mm) and a hammer, remove the select inner lever slotted spring pin, select inner lever, select return compression spring No. 1 and select spring seat No. 1 from shift and select lever shaft.

    HINT:
    Check the orientation of the select inner lever.



5. REMOVE SELECT SPRING NO.1 SEAT SHAFT SNAP RING


C120737
  1. Using 2 screwdrivers and a hammer, remove the select spring No. 1 seat shaft snap ring.