Home › Audio / Visual / Telematics › AUDIO / VIDEO › FRONT DOOR SPEAKER (for Sedan)

FRONT DOOR SPEAKER (for Sedan) > ON-VEHICLE INSPECTION



1. INSPECT FRONT NO. 1 SPEAKER ASSEMBLY

HINT:
Remove interior parts so that the front No. 1 speaker can be seen.

  1. Check the installation.

    OK:
    The speaker is securely installed.

    If the result is not as specified, reinstall the front No. 1 speaker.

  1. Visually check the speaker.

    OK:
    The cone paper of the speaker is not torn.

    If the result is not as specified, replace the front No. 1 speaker.



    B134971E01
  1. Check the resistance.

    1. Disconnect the speaker connector.

    2. Using an ohmmeter, measure the resistance between the terminals.

      Standard resistance:
      Tester Connection
      Specified Condition
      1 - 2
      Approximately 4 Ω

      If the result is not as specified, replace the front No. 1 speaker.