Home › Suspension › REAR SUSPENSION › REAR SHOCK ABSORBER (for Sedan)

REAR SHOCK ABSORBER (for Sedan) > DISPOSAL



1. DISPOSE OF REAR SHOCK ABSORBER


C116872E01
  1. Fully extend the shock absorber piston rod.

  1. Using a drill or similar tool, slowly make a hole in the area (A-B) shown in the illustration to discharge the gas inside.

    NOTICE:
    1. The gas is colorless, odorless and harmless.
    2. Since the discharging gas may cause chips to scatter, cover the drill with a shop rag or piece of cloth when making the hole.