Home › Suspension › REAR SUSPENSION › REAR SHOCK ABSORBER (for Sedan)

REAR SHOCK ABSORBER (for Sedan) > INSTALLATION



1. INSTALL REAR SUSPENSION SUPPORT ASSEMBLY


2. INSTALL REAR SUSPENSION SUPPORT STOPPER


3. TEMPORARILY TIGHTEN REAR SHOCK ABSORBER
  1. Support the rear axle beam with a jack. Insert a wooden block between the jack and the rear axle spring seat to prevent damage.

  1. Jack up the rear axle beam slowly, and temporarily tighten the rear shock absorber (lower side) to the rear axle beam with the bolt and nut.

  1. Install the rear suspension support and the rear shock absorber cushion retainer.



    C106033
  1. While holding the rear shock absorber piston rod, install a new nut (lower nut) to the specified standard.

    Standard:
    15 to 18 mm (0.591 to 0.708 in.)

  1. Install a new nut (upper nut) onto the lower nut.

  1. Hold the lower nut and tighten the upper nut against it.

    Torque:
    25 N*m{ 250 kgf*cm , 18 ft.*lbf }



4. INSTALL REAR WHEEL

Torque:
103 N*m{ 1050 kgf*cm , 76 ft.*lbf }



5. STABILIZE SUSPENSION
  1. Lower the vehicle from the jack.

  1. Bounce the vehicle up and down several times to stabilize the suspension.



6. FULLY TIGHTEN REAR SHOCK ABSORBER
  1. Fully tighten the rear shock absorber (lower side) with the bolt.

    Torque:
    49 N*m{ 500 kgf*cm , 36 ft.*lbf }

    NOTICE:
    Since a stopper nut is used, turn the bolt.



7. INSPECT REAR WHEEL ALIGNMENT
(Click here)