POWER STEERING SYSTEM (for Sedan) > EPS Warning Light Circuit |

| 1.INSPECT CAN COMMUNICATION SYSTEM |
Using a Techstream, check for DTCs and confirm that there are no problems in the CAN communication system.
|
| ||||
| OK | |
| 2.READ VALUE USING TECHSTREAM |
Connect a Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Enter the following menus: Chassis / EMPS / Data List.
Select the item "IG Power Supply" in the Data List and read the value displayed on the Techstream.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| IG Power Supply | ECU power source voltage: Minimum: 0.0000 V, Maximum: 20.1531 V | 11 to 14 V: Ignition switch ON | - |
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (POWER STEERING ECU - BODY GROUND) |
![]() |
Disconnect the connectors from the power steering ECU.
Measure the voltage and the resistance.
| Tester Connection | Condition | Specified Condition |
| IG (D31-6) - Body ground | Ignition switch on | 11 to 14 V |
| PGND (A19-2) - Body ground | Always | Below 1 Ω |
|
| ||||
| OK | |
| 4.REPLACE POWER STEERING ECU |
| NEXT | |
| 5.CHECK EPS WARNING LIGHT (COMBINATION METER) |
Check that the EPS warning light on the combination meter does not come on.
|
| ||||
| OK | ||
| ||