POWER STEERING SYSTEM (for Sedan) > TS and CG Terminal Circuit |

| 1.INSPECT DLC3 TERMINAL VOLTAGE |
![]() |
Turn the ignition switch to ON.
Measure the voltage.
| Tester Connection | Condition | Specified Condition |
| TS (12) - CG (4) | Always | 11 to 14 V |
|
| ||||
| NG | |
| 2.CHECK HARNESS AND CONNECTOR (DLC3 - BODY GROUND) |
![]() |
Measure the resistance.
| Tester Connection | Condition | Specified Condition |
| CG (4) - Body ground | Always | Below 1 Ω |
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (POWER STEERING ECU - DLC3) |
![]() |
Disconnect the connector from the power steering ECU.
Measure the resistance.
| Tester Connection | Condition | Specified Condition |
| TS (D31-11) -TS (12) | Always | Below 1 Ω |
| TS (D31-11) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||