POWER STEERING SYSTEM (for Hatchback) > DTC CHECK / CLEAR |
| CHECK DTC |
Turn the ignition switch off.
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Enter the following menus: Chassis / EMPS / Trouble Codes.
Read the DTCs following the display on the Techstream.
Refer to Diagnostic Trouble Code Chart for DTC information (Click here).
| CLEAR DTC |
Turn the ignition switch off.
Connect the Techstream to the DLC3.
Start the engine.
Turn the Techstream on.
Enter the following menus: Chassis / EMPS / Trouble Codes.
Clear the DTCs by following the display on the Techstream.
Turn the ignition switch off.
Disconnect the Techstream from the DLC3.