POWER STEERING SYSTEM (for Sedan) > TEST MODE PROCEDURE |
| TEST MODE START-UP |
When using a Techstream;
Turn the ignition switch to OFF.
Connect a Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Enter the following menus: Chassis / EMPS / Utility / Signal Check.
![]() |
When not using a Techstream;
Turn the ignition switch to OFF and connect terminals 12 (TS) and 4 (CG) of the DLC3.
Turn the ignition switch to ON.
| CHECK TEST MODE DISPLAY |
![]() |
The EPS warning light blinks as shown on the left when test mode is entered.
| READ TEST MODE CODE |
When using a Techstream;
Check the DTCs in test mode.
![]() |
When not using the Techstream;
Turn the ignition switch to OFF.
Connect terminals 12 (TS) and 4 (CG) of the DLC3, and also terminals 13 (TC) and 4 (CG) of the DLC3.
![]() |
Read the number of times that the EPS warning light on the combination meter blinks.
| END OF TEST MODE |
When using a Techstream;
Return to normal mode by following the instructions on the tester screen.
Turn the ignition switch to OFF and disconnect the tester.
When not using the Techstream;
Turn the ignition switch to OFF and disconnect terminals 13 (TC) and 4 (CG), and terminals 12 (TS) and 4 (CG) of the DLC3.
Turn the ignition switch to ON.
| Code | Detection Item | Conditions to clear code | Trouble areas |
| C1571/71 | Vehicle speed check | Vehicle speed 6 mph (10 Km/h) or more | If code cannot be cleared, any of following areas may malfunction.
|