Home › Suspension › FRONT SUSPENSION › FRONT STABILIZER BAR (for Sedan)

FRONT STABILIZER BAR (for Sedan) > INSPECTION



1. INSPECT FRONT STABILIZER LINK ASSEMBLY


G021679
  1. As shown in the illustration, flip the ball joint stud back and forth 5 times before installing the nut.

  1. Using a torque wrench, turn the nut continuously at a rate of 3 to 5 seconds per turn and take the torque reading on the 5th turn.

    Torque:
    1.0 N*m{ 10 kgf*cm , 8.9 in.*lbf } or less

  1. Check for any cracks and grease leakage on the ball joint dust cover.