Home › Suspension › REAR SUSPENSION › REAR COIL SPRING (for Sedan)

REAR COIL SPRING (for Sedan) > REMOVAL



1. REMOVE REAR WHEEL


2. DRAIN BRAKE FLUID

NOTICE:
Immediately wash off any brake fluid that comes into contact with any painted surfaces.



3. SEPARATE SKID CONTROL SENSOR WIRE (w/ ABS)


    C125279
  1. Using a screwdriver, disengage the claw of the connector lock portion and disconnect the skid control sensor wire connector.

    NOTICE:
    Do not remove the connector cover from the connector because the skid control sensor wire may be damaged.



    C107566
  1. Remove the nut and separate the skid control sensor wire from the rear axle beam.



4. SEPARATE REAR FLEXIBLE HOSE LH


C204010
  1. Using a 10 mm union nut wrench, disconnect the rear No. 4 brake tube while holding the rear flexible hose LH with a wrench.

  1. Remove the clip and separate the rear flexible hose LH from the rear axle beam.



5. SEPARATE REAR FLEXIBLE HOSE RH

HINT:
The removal procedure for the RH side is the same as that for the LH side.



6. LOOSEN REAR AXLE BEAM


C112605E09
  1. Loosen the 2 bolts.
    Text in Illustration 
    *a
    RH Side
    *b
    LH Side

    NOTICE:
    Do not remove the bolts.



7. REMOVE REAR COIL SPRING LH


  1. Support the spring seat of the rear axle beam with an engine lifter using 2 wooden blocks as shown in the illustration.


    C288466E01


    *a
    Wooden Block
    *b
    Engine Lifter

  1. Remove the 2 bolts while holding the 2 nuts and separate the rear axle beam from the rear shock absorber assemblies LH and RH.

    NOTICE:
    Since a stopper nut is used, turn the bolt.

  1. Slowly lower the rear axle beam with an engine lifter and 2 wooden blocks.

  1. Remove the rear coil spring LH, rear upper coil spring insulator LH and the rear lower coil spring insulator LH.

  1. Slowly jack up the rear axle beam with an engine lifter using 2 wooden blocks, and temporarily tighten the rear axle beam to the rear shock absorber assemblies LH and RH with the 2 bolts and 2 nuts.

    NOTICE:
    Since a stopper nut is used, turn the bolt.



8. REMOVE REAR COIL SPRING RH

HINT:
The removal procedure for the RH side is the same as that for the LH side.