Home › Drivetrain ยท CLUTCH › CLUTCH RELEASE CYLINDER (for Sedan)

CLUTCH RELEASE CYLINDER (for Sedan) > REASSEMBLY



1. INSTALL RELEASE CYLINDER BLEEDER PLUG

Torque:
8.3 N*m{ 85 kgf*cm , 73 in.*lbf }



2. INSTALL CLUTCH RELEASE CYLINDER KIT
  1. Install the bleeder plug cap onto the bleeder plug.

  1. Install the spring onto the cylinder body.



    CL00672E01
  1. Coat a new piston with lithium soap base glycol grease, as shown in the illustration.

  1. Install the piston onto the cylinder body.

    NOTICE:
    Do not damage the inside of the cylinder body.

  1. Install the push rod onto the cylinder body.

  1. Install the boot onto the cylinder body.