Home › Drivetrain ยท CLUTCH › CLUTCH UNIT (for Sedan)

CLUTCH UNIT (for Sedan) > INSTALLATION

for Preparation Click here



1. INSTALL CLUTCH DISC ASSEMBLY


    C241301E02
  1. Insert SST into the clutch disc assembly, then insert them both into the flywheel sub-assembly.
    Text in Illustration 
    *a
    Flywheel Side

    SST
    09301-00210  

    NOTICE:
    Insert the clutch disc assembly in the correct direction.



2. INSTALL CLUTCH COVER ASSEMBLY


    D026323E14
  1. Align the matchmark on the clutch cover assembly with that on the flywheel sub-assembly.
    Text in Illustration 
    *a
    Temporally
    *b
    Matchmark

  1. Following the procedures shown in the illustration, tighten the 6 bolts in order, starting with the bolt located near the knock pin at the top.

    Torque:
    19 N*m{ 195 kgf*cm , 14 ft.*lbf }

    HINT:
    1. Following the order in the illustration, tighten the bolts evenly one at a time.
    2. Move SST up and down, right and left lightly after checking that the disc is in the center, and tighten the bolts.

    SST
    09301-00210  



3. INSPECT AND ADJUST CLUTCH COVER ASSEMBLY


C062961
  1. Using a dial indicator with a roller instrument, check the diaphragm spring tip alignment.

    Maximum non-alignment:
    0.5 mm (0.020 in.)



    D029849E01
  1. If the alignment is not as specified, using SST, adjust the diaphragm spring tip alignment.

    SST
    09333-00013  



4. INSTALL RELEASE FORK SUPPORT
  1. Install the release fork support onto the transaxle assembly.

    Torque:
    37 N*m{ 375 kgf*cm , 27 ft.*lbf }



5. INSTALL CLUTCH RELEASE FORK BOOT


6. INSTALL RELEASE BEARING HUB CLIP


7. INSTALL CLUTCH RELEASE FORK SUB-ASSEMBLY


    D025284E05
  1. Apply release hub grease to the contact surfaces of the release fork and release bearing assembly, release fork and push rod, and release fork and fork support.
    Text in Illustration 
    *1
    Release Hub Grease

    Grease:
    Toyota Genuine Release Hub Grease or Equivalent

  1. Install the release fork onto the release bearing assembly.



8. INSTALL CLUTCH RELEASE BEARING ASSEMBLY


    C137978E12
  1. Apply clutch spline grease to the input shaft spline.
    Text in Illustration 
    *1
    Clutch Spline Grease

    Grease:
    Toyota Genuine Clutch Spline Grease or Equivalent

    NOTICE:
    Do not apply grease to portion A shown in the illustration.

  1. Install the clutch release bearing with release fork onto the transaxle assembly.

    NOTICE:
    After the installation, move the fork forward and backward to check that the release bearing slides smoothly.



9. INSTALL MANUAL TRANSAXLE ASSEMBLY
(Click here)