Home › Drivetrain ยท CLUTCH › CLUTCH PEDAL SWITCH (for Sedan)

CLUTCH PEDAL SWITCH (for Sedan) > INSTALLATION



1. INSTALL CLUTCH START SWITCH ASSEMBLY


C116855
  1. Install the clutch start switch with the nut.

    Torque:
    16 N*m{ 160 kgf*cm , 12 ft.*lbf }

    NOTICE:
    Insert the protrusion of the clutch start switch into the hole in the clutch pedal support.

  1. Connect the clutch start switch connector.



2. INSPECT CLUTCH START SWITCH ASSEMBLY


C115311
  1. Check that the engine does not start when the clutch pedal is released.

  1. Check that the engine starts when the clutch pedal is fully depressed.
    If necessary, replace the clutch start switch assembly.