CLUTCH PEDAL SWITCH (for Hatchback) > INSTALLATION |
| 1. INSTALL NO. 2 CLUTCH START SWITCH ASSEMBLY |
Install the No. 2 clutch start switch assembly to the clutch pedal support sub-assembly and temporarily tighten the lock nut.
| 2. INSTALL CLUTCH START SWITCH ASSEMBLY |
Install the clutch start switch assembly to the clutch pedal support sub-assembly with the nut.
Connect the clutch start switch connector.
![]() |
With the clutch pedal fully depressed, check that the clearance shown in the illustration is as specified.
| *a | Clearance |
![]() | Fully depressed |
| 3. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL (w/o Knee Airbag) |
Engage the 5 claws and 2 clips and install the instrument panel finish panel.
| 4. INSTALL LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY (w/ Knee Airbag) |
| 5. INSTALL LOWER NO. 2 INSTRUMENT PANEL FINISH PANEL |
Engage the 2 claws and 5 clips and install the instrument panel finish panel.
| 6. INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY |
Engage the guide and the claw.
Install the instrument panel under cover with the 2 <A> screws.
| 7. INSPECT CLUTCH START SYSTEM |
Check that the engine does not start when the clutch pedal is released.
Check that the engine starts when the clutch pedal is fully depressed.
If necessary, replace the clutch start switch assembly.