Home › Drivetrain · CLUTCH › CLUTCH PEDAL SWITCH (for Hatchback)

CLUTCH PEDAL SWITCH (for Hatchback) > INSPECTION



1. INSPECT CLUTCH START SWITCH ASSEMBLY


    D011485E34
  1. Measure the resistance according to the value(s) in the table below.
    Text in Illustration 
    *a
    Component without harness connected
    (Clutch Start Switch Assembly)
    *b
    7.65 to 8.35 mm (0.301 to 0.329 in.)

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    1 - 2
    ON (Pushed in)
    Below 1Ω
    OFF (Released)
    10 kΩ or higher

    If the resistance is not as specified, replace the clutch start switch assembly.



2. INSPECT NO. 2 CLUTCH START SWITCH ASSEMBLY


    C195260E03
  1. Measure the resistance according to the value(s) in the table below.
    Text in Illustration 
    *a
    Component without harness connected
    (No. 2 Clutch Start Switch Assembly)
    *b
    6.5 to 7.5 mm (0.256 to 0.295 in.)

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    1 - 2
    ON (Pushed in)
    Below 1Ω
    OFF (Released)
    10 kΩ or higher

    If the resistance is not as specified, replace the No. 2 clutch start switch assembly.