Home › Drivetrain ยท CLUTCH › CLUTCH PEDAL SWITCH (for Hatchback)

CLUTCH PEDAL SWITCH (for Hatchback) > REMOVAL



1. REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY


    B284272
  1. Remove the 2 <A> screws.

  1. Disengage the claw and the guide and remove the instrument panel under cover.



2. REMOVE LOWER NO. 2 INSTRUMENT PANEL FINISH PANEL


    B284273
  1. Disengage the 5 clips and the 2 claws and remove the instrument panel finish panel.



3. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL (w/o Knee Airbag)


    B284274
  1. Disengage the 2 clips and the 5 claws and remove the instrument panel finish panel.



4. REMOVE LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY (w/ Knee Airbag)
(Click here)


5. REMOVE CLUTCH START SWITCH ASSEMBLY
  1. Disconnect the clutch start switch connector.



    C187734
  1. Remove the nut and the clutch start switch assembly from the clutch pedal support sub-assembly.



6. REMOVE NO. 2 CLUTCH START SWITCH ASSEMBLY
  1. Disconnect the No. 2 clutch start switch connector.



    C242410
  1. Loosen the lock nut and remove the No. 2 clutch start switch assembly from the clutch pedal support sub-assembly.