TRANSMISSION CONTROL CABLE (for Sedan) > INSTALLATION |
| 1. INSTALL TRANSMISSION CONTROL CABLE ASSEMBLY |
![]() |
Install the control cable with the 3 nuts.
![]() |
Install the control shift cable onto the shift lever retainer.
Connect the control shift cable to the shift lever.
Install the control shift cable onto the control cable bracket with a new clip.
Connect the control shift cable to the transaxle through the washer.
![]() |
Install the control select cable onto the shift lever retainer.
![]() |
Connect the control select cable to the shift lever with the clip.
Install the control select cable onto the control cable bracket with a new clip.
Connect the control select cable to the transaxle through the washer.
| 2. ADJUST TRANSMISSION CONTROL CABLE ASSEMBLY |
Remove the console box assembly .
![]() |
Remove the clip and disconnect the control select cable from the shift lever assembly.
![]() |
Adjust the length of the control select cable.
Slide the adjuster case cover in the direction shown in the illustration (Illustration A).
Gently pull the cable rod toward the rear of the vehicle by hand to pull the cable taut.
Press the lock piece into the adjuster case and lock it (Illustration B).
Slide the cover in the direction shown in the illustration (Illustration C).
Install the clip to the shift lever assembly.
Install the console box assembly .
| 3. INSTALL FRONT FLOOR HEAT INSULATOR NO.1 |
Install floor heat insulator No. 1 with the 2 bolts and nut.
| 4. INSTALL EXHAUST PIPE ASSEMBLY FRONT |
![]() |
Using vernier calipers, measure the free length of the compression spring.
![]() |
Using a plastic hammer and a wooden block, tap in a new exhaust pipe gasket until its surface is flush with the front exhaust pipe assembly.
Install the 3 No. 4 exhaust pipe supports and front exhaust pipe assembly.
Install the exhaust front pipe assembly and a new exhaust pipe gasket with the 4 compression springs and 4 bolts.

| 5. CONNECT OXYGEN SENSOR CONNECTOR |
| 6. INSTALL REAR CONSOLE BOX ASSEMBLY |
![]() |
Engage the 4 claws and install the rear console box.
Install the 2 bolts and 2 screws.
Connect the clamp.
| 7. INSTALL CONSOLE BOX CARPET |
![]() |
Install the console box carpet.
| 8. INSTALL CONSOLE UPPER REAR PANEL SUB-ASSEMBLY |
![]() |
Connect the connector.
Engage the 3 clips and 3 claws and install the console upper rear panel.
| 9. INSTALL UPPER CONSOLE PANEL SUB-ASSEMBLY |
![]() |
Engage the 5 clips and the claw and install the upper console panel.
| 10. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY |
![]() |
Install the shift lever knob.
| 11. INSTALL INSTRUMENT PANEL FINISH PANEL LOWER CENTER |
![]() |
Engage the 2 claws and 2 clips and install the instrument panel finish panel lower center.
| 12. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |