Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › BRAKE ACTUATOR (for Sedan)

BRAKE ACTUATOR (for Sedan) > REMOVAL



1. DRAIN BRAKE FLUID

NOTICE:
Immediately wash off any brake fluid that comes into contact with any painted surfaces.



2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL


3. REMOVE BATTERY
  1. Disconnect the cable from the battery terminal.

  1. Loosen the nut and remove the battery clamp.

  1. Remove the battery.



4. REMOVE BATTERY TRAY


5. REMOVE BATTERY CARRIER


A117309
  1. Separate the wire harness clamp from the battery carrier.

  1. Remove the 5 bolts and remove the battery carrier.



6. REMOVE BRAKE ACTUATOR ASSEMBLY


    C228099E02
  1. Release the lock lever and disconnect the brake actuator connector.
    Text in Illustration 
    *1
    Lock Lever

    NOTICE:
    Be careful not to allow brake fluid to enter the removed connector.



    C241445
  1. Using a 10 mm union nut wrench, separate the 6 brake tubes from the brake actuator assembly.



    C241446E01
  1. Use tags or labels to identify the place to reconnect each brake tube.
    Text in Illustration 
    *a
    to Front Wheel Cylinder RH
    *b
    to Front Wheel Cylinder LH
    *c
    to Rear Wheel Cylinder RH
    *d
    to Rear Wheel Cylinder LH
    *e
    from 1st Master Cylinder
    *f
    from 2nd Master Cylinder



    C168356
  1. Remove the 3 bolts and the brake actuator assembly with brake actuator bracket assembly.

    NOTICE:
    Do not damage the brake tubes or wire harness.



7. REMOVE BRAKE ACTUATOR BRACKET ASSEMBLY


    C241442
  1. Remove the 3 bolts and the brake actuator bracket assembly.