Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › BRAKE ACTUATOR (for Hatchback)

BRAKE ACTUATOR (for Hatchback) > REMOVAL



1. DRAIN BRAKE FLUID

NOTICE:
Immediately wash off any brake fluid that comes into contact with any painted surfaces.



2. REMOVE BATTERY


    A248909
  1. Disconnect the cable from the battery terminal.

  1. Loosen the 2 nuts and remove the battery clamp.

  1. Remove the battery.



3. REMOVE BATTERY TRAY


4. REMOVE BATTERY CARRIER


    A259809
  1. Disengage the 6 clamps and disconnect the wire harness from the battery carrier.

  1. Remove the 5 bolts and the battery carrier.



5. REMOVE BRAKE ACTUATOR ASSEMBLY (w/o VSC)


    C228099E02
  1. Release the lock lever and disconnect the brake actuator connector.
    Text in Illustration 
    *1
    Lock lever

    NOTICE:
    Be careful not to allow brake fluid to enter the removed connector.



    C245949
  1. Using a union nut wrench 10 mm, separate the 6 brake tubes from the brake actuator.



    C234485
  1. Remove the 3 bolts and brake actuator with bracket from the side member.

    NOTICE:
    Do not damage the brake tubes or wire harness.



6. REMOVE BRAKE ACTUATOR ASSEMBLY (w/ VSC)


    C228099E02
  1. Release the lock lever and disconnect the brake actuator connector.
    Text in Illustration 
    *1
    Lock lever

    NOTICE:
    Be careful not to allow brake fluid to enter the removed connector.



    C215142
  1. Using a union nut wrench 10 mm and union nut wrench 12 mm, separate the 6 brake tubes from the brake actuator.
    Text in Illustration 
    V100135
    Flare Nut 10 mm
    V100136
    Flare Nut 12 mm



    C234485
  1. Remove the 3 bolts and brake actuator with bracket from the side member.

    NOTICE:
    Do not damage the brake tubes or wire harness.



7. REMOVE BRAKE ACTUATOR BRACKET ASSEMBLY


    C168361
  1. Remove the 3 bolts and brake actuator bracket assembly.



8. REMOVE BRAKE ACTUATOR BOLT CUSHION
  1. Remove the 3 brake actuator case collars from the brake actuator bolt cushion.

  1. Remove the 3 brake actuator bolt cushions from the brake actuator bracket assembly.