PARKING BRAKE CABLE (for Hatchback Disc Type) > INSTALLATION |
| 1. INSTALL NO. 3 PARKING BRAKE CABLE ASSEMBLY |
Insert the parking brake cable into the disc brake cylinder and engage the clip claws of the parking brake cable to the rear disc brake cylinder guide.
Connect the cable end to the rear disc brake cylinder operation lever.
Install cable clamp B onto the rear axle beam.
Tighten the 5 bolts.
Pass the parking brake cable through a new cable clamp A, and then install cable clamp A onto the stud bolt.
Connect the No. 3 parking brake cable assembly onto the parking brake equalizer.
| 2. INSTALL NO. 2 PARKING BRAKE CABLE ASSEMBLY |
| 3. INSTALL FUEL TANK COVER VENT CASE SUB-ASSEMBLY |
Install the fuel tank cover vent case sub-assembly with the bolt and clip.
| 4. INSTALL FRONT NO. 4 FLOOR HEAT INSULATOR |
Install the front No. 4 floor heat insulator with the 2 nuts.
| 5. INSTALL REAR WHEEL |
| 6. ADJUST PARKING BRAKE LEVER TRAVEL |
Remove the rear console box (Click here).
![]() |
Turn the lock nut until the parking brake lever travel is corrected to within the specified range.
| *1 | Lock nut |
Operate the parking brake lever 3 to 4 times, and check the parking brake lever travel.
Check whether the parking brake drags or not.
![]() |
Release the parking brake lever and check that the clearance measurement between the rear disc brake cylinder operation lever and the stopper is within the specified range.
| *1 | Stopper |
| *2 | Operation Lever |
Install the rear console box (Click here).
| 7. INSTALL REAR CONSOLE BOX ASSEMBLY |