Home › Brake › PARKING BRAKE › PARKING BRAKE CABLE (for Sedan)

PARKING BRAKE CABLE (for Sedan) > REMOVAL

for Preparation Click here



1. REMOVE CENTER LOWER INSTRUMENT PANEL FINISH PANEL


B132316
  1. Disengage the 2 claws and 2 clips and remove the instrument panel finish panel.



2. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY (for Manual Transaxle)


3. REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY


B132347
  1. Shift the shift lever into the N position.

  1. Disengage the 5 clips and the claw and remove the upper console panel.



4. REMOVE REAR UPPER CONSOLE PANEL SUB-ASSEMBLY


B132348
  1. Disengage the 3 clips and 3 claws.

  1. Disconnect the connector and remove the rear upper console panel.



5. REMOVE CONSOLE BOX CARPET


    B132346
  1. Remove the console box carpet.



6. REMOVE REAR CONSOLE BOX ASSEMBLY


    B132349
  1. Disconnect the clamp.

  1. Remove the 2 bolts and 2 screws.

  1. Disengage the 4 claws and remove the rear console box.



7. REMOVE REAR WHEEL


8. REMOVE REAR BRAKE DRUM SUB-ASSEMBLY
  1. Release the parking brake and remove the rear brake drum.
    If the rear brake drum cannot be removed easily, perform the following procedure.



    F046068E02
  1. Remove the hole plug and insert a screwdriver through the hole into the backing plate, and hold the automatic adjust lever away from the adjuster.

  1. Using another screwdriver, contract the brake shoe by turning the adjusting bolt.



9. REMOVE REAR BRAKE SHOE KIT


C108968E01
  1. Using SST, separate the shoe return spring from the front brake shoe.

    SST
    09703-30010  

    NOTICE:
    Do not damage the wheel cylinder boot.



    C108969E01
  1. Using SST, remove the shoe hold down spring cup, shoe hold down spring, pin and front brake shoe.

    SST
    09718-00010  

  1. Remove the tension spring.



    C108970
  1. Remove the shoe return spring from the rear brake shoe and remove the parking brake shoe strut set.



    C108971E01
  1. Using SST, remove the shoe hold down spring cup, shoe hold down spring, pin and rear brake shoe.

    SST
    09718-00010  



    C108972
  1. Using needle-nose pliers, separate the parking brake cable.



10. REMOVE FRONT FLOOR NO. 4 HEAT INSULATOR


C108997
  1. Remove the 2 nuts and remove the heat insulator.



11. REMOVE FUEL TANK COVER VENT CASE SUB-ASSEMBLY (for RH Side)


A118750E02
  1. Pinch and remove the clip as shown in the illustration.

  1. Remove the bolt and fuel tank cover vent case.



12. LOOSEN NO. 1 WIRE ADJUSTING NUT


C116905E01
  1. Loosen the lock nut and the adjusting nut.



13. REMOVE PARKING BRAKE CABLE
  1. Disconnect the cable end from the equalizer.



  1. Remove cable clamp A from the body.


    C162915E01

  1. Remove the 4 bolts.

  1. Using pliers, pinch both ends of the claw of cable clamp B and flex the clamp to remove it.



    C109000
  1. Remove the bolt and remove the parking brake cable from the backing plate.

  1. Remove the cable clamp B from the parking brake cable.

    HINT:
    Replace the cable clamp B with a new one when installing the parking brake cable.