PARKING BRAKE CABLE (for Hatchback Drum Type) > REMOVAL |
| 1. REMOVE REAR CONSOLE BOX ASSEMBLY |
| 2. LOOSEN PARKING BRAKE CABLE |
![]() |
Loosen the equalizer and lock nut.
| *1 | Parking Brake Equalizer |
| *2 | Lock Nut |
| 3. REMOVE REAR WHEEL |
| 4. REMOVE REAR BRAKE DRUM SUB-ASSEMBLY |
Release the parking brake and remove the rear brake drum.
If the rear brake drum cannot be removed easily, perform the following procedure.
![]() |
Remove the hole plug and insert a screwdriver through the hole into the backing plate, and hold the automatic adjust lever away from the adjuster.
| *1 | Automatic Adjust Lever |
![]() | Contract |
Using another screwdriver, contract the brake shoe by turning the adjusting bolt.
| 5. REMOVE REAR BRAKE SHOE KIT |
![]() |
Using SST, separate the shoe return spring from the front brake shoe.
![]() |
Using SST, remove the shoe hold down spring cup, shoe hold down spring, pin and front brake shoe.
Remove the tension spring.
![]() |
Remove the shoe return spring from the rear brake shoe and remove the parking brake shoe strut set.
![]() |
Using SST, remove the shoe hold down spring cup, shoe hold down spring, pin and rear brake shoe.
![]() |
Using needle-nose pliers, separate the parking brake cable.
| 6. REMOVE FRONT NO. 4 FLOOR HEAT INSULATOR |
![]() |
Remove the 2 nuts and the front No. 4 floor heat insulator.
| 7. REMOVE FUEL TANK COVER VENT CASE SUB-ASSEMBLY |
![]() |
Pinch and remove the clip as shown in the illustration.
Remove the bolt and the fuel tank cover vent case sub-assembly.
| 8. REMOVE NO. 3 PARKING BRAKE CABLE ASSEMBLY |
![]() |
Separate the No. 3 parking brake cable assembly from the parking brake equalizer.
| *1 | Parking Brake Equalizer |
| *2 | No. 2 parking brake cable assembly |
| *3 | No. 3 parking brake cable assembly |
Remove cable clamp A from the body.

Remove the 5 bolts.
Remove cable clamp B from the rear axle beam.
![]() |
Remove the bolt and No. 3 parking brake cable assembly from the backing plate.
| 9. REMOVE NO. 2 PARKING BRAKE CABLE ASSEMBLY |