PARKING BRAKE CABLE (for Hatchback Disc Type) > REMOVAL |
| 1. REMOVE REAR CONSOLE BOX ASSEMBLY |
| 2. LOOSEN PARKING BRAKE CABLE |
![]() |
Loosen the equalizer and lock nut.
| *1 | Parking Brake Equalizer |
| *2 | Lock Nut |
| 3. REMOVE REAR WHEEL |
| 4. REMOVE FRONT NO. 4 FLOOR HEAT INSULATOR |
![]() |
Remove the 2 nuts and the front No. 4 floor heat insulator.
| 5. REMOVE FUEL TANK COVER VENT CASE SUB-ASSEMBLY |
![]() |
Pinch and remove the clip as shown in the illustration.
Remove the bolt and the fuel tank cover vent case sub-assembly.
| 6. REMOVE NO. 3 PARKING BRAKE CABLE ASSEMBLY |
![]() |
Separate the parking brake cable from the parking brake equalizer
| *1 | Parking Brake Equalizer |
| *2 | No. 2 parking brake cable assembly |
| *3 | No. 3 parking brake cable assembly |
Remove cable clamp A from the body.

Remove the 5 bolts.
Remove cable clamp B from the rear axle beam.
![]() |
Separate the No. 3 parking brake cable assembly from the rear disc brake operation lever.
![]() |
Insert an offset wrench 14 mm at the base of the parking brake cable as shown in the illustration to disengage the clip. Pull out the No. 3 parking brake cable assembly from the rear disc brake cylinder.
| *1 | No. 3 Parking Brake Cable Assembly |
| *2 | Clip |
| *3 | Offset Wrench 14 mm |
| 7. REMOVE NO. 2 PARKING BRAKE CABLE ASSEMBLY |