Home › Brake › PARKING BRAKE › PARKING BRAKE SWITCH (for Sedan)

PARKING BRAKE SWITCH (for Sedan) > INSTALLATION



1. INSTALL PARKING BRAKE SWITCH


C109013
  1. Install the parking brake switch with the screw.

    Torque:
    0.9 N*m{ 9 kgf*cm , 8 in.*lbf }

  1. Connect the parking brake switch connector.



2. INSTALL REAR CONSOLE BOX ASSEMBLY


    B132349
  1. Engage the 4 claws and install the rear console box.

  1. Install the 2 bolts and 2 screws.

  1. Connect the clamp.



3. INSTALL CONSOLE BOX CARPET


    B132346
  1. Install the console box carpet.



4. INSTALL REAR UPPER CONSOLE PANEL SUB-ASSEMBLY


B132348
  1. Connect the connector.

  1. Engage the 3 clips and 3 claws and install the rear upper console panel.



5. INSTALL UPPER CONSOLE PANEL SUB-ASSEMBLY


B132347
  1. Engage the 5 clips and the claw and install the upper console panel.



6. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY (for Manual Transaxle)


7. INSTALL CENTER LOWER INSTRUMENT PANEL FINISH PANEL


B132316
  1. Engage the 2 claws and 2 clips and install the instrument panel finish panel.



8. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque:
5.4 N*m{ 55 kgf*cm , 48 in.*lbf }