Home › Brake › PARKING BRAKE › PARKING BRAKE SWITCH (for Hatchback)

PARKING BRAKE SWITCH (for Hatchback) > INSPECTION



1. INSPECT PARKING BRAKE SWITCH ASSEMBLY


    C230989E01
  1. Measure the resistance between the connector terminal and the nut inside the parking brake switch assembly.
    Text in Illustration 
    *a
    Component without harness connected
    (Parking Brake Switch Assembly)
    V100135
    ON
    V100136
    OFF
    Standard Resistance 
    Tester Connection
    Switch Condition
    Specified Condition
    1 - Switch body
    Parking brake switch ON
    (Switch pin free)
    Below 1 Ω
    Parking brake switch OFF
    (Switch pin pushed in)
    10 kΩ or higher
    If the value is not as specified, replace the parking brake switch assembly.