Home › Brake › PARKING BRAKE › PARKING BRAKE SWITCH (for Sedan)

PARKING BRAKE SWITCH (for Sedan) > REMOVAL



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL


2. REMOVE CENTER LOWER INSTRUMENT PANEL FINISH PANEL


B132316
  1. Disengage the 2 claws and 2 clips and remove the instrument panel finish panel.



3. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY (for Manual Transaxle)


4. REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY


B132347
  1. Shift the shift lever into the N position.

  1. Disengage the 5 clips and the claw and remove the upper console panel.



5. REMOVE REAR UPPER CONSOLE PANEL SUB-ASSEMBLY


B132348
  1. Disengage the 3 clips and 3 claws.

  1. Disconnect the connector and remove the rear upper console panel.



6. REMOVE CONSOLE BOX CARPET


    B132346
  1. Remove the console box carpet.



7. REMOVE REAR CONSOLE BOX ASSEMBLY


    B132349
  1. Disconnect the clamp.

  1. Remove the 2 bolts and 2 screws.

  1. Disengage the 4 claws and remove the rear console box.



8. REMOVE PARKING BRAKE SWITCH
  1. Disconnect the parking brake switch connector.



    C109013
  1. Remove the screw and remove the parking brake switch.