Home › Brake › PARKING BRAKE › PARKING BRAKE SYSTEM (for Sedan)

PARKING BRAKE SYSTEM (for Sedan) > ADJUSTMENT



1. REMOVE REAR WHEEL


2. ADJUST REAR DRUM BRAKE SHOE CLEARANCE
  1. Provisionally install the 2 hub nuts.



    F040023E07
  1. Remove the hole plug, and turn the adjuster to expand the shoe until the drum locks.
    Text in Illustration 
    *1
    Automatic Adjust Lever
    V100135
    Expand

  1. Using a screwdriver, release the adjuster 12 notches.

  1. Install the hole plug.



3. INSTALL REAR WHEEL

Torque:
103 N*m{ 1,050 kgf*cm , 76 ft.*lbf }



4. INSPECT PARKING BRAKE LEVER TRAVEL
  1. Slowly pull the parking brake lever to the fully applied position, counting the number of clicks.

    Parking brake lever travel:
    6 to 9 clicks at 200 N (20 kgf, 45 lbf)



5. REMOVE CENTER LOWER INSTRUMENT PANEL FINISH PANEL


B132316
  1. Disengage the 2 claws and 2 clips and remove the instrument panel finish panel.



6. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY (for Manual Transaxle)


7. REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY


B132347
  1. Shift the shift lever into the N position.

  1. Disengage the 5 clips and the claw and remove the upper console panel.



8. REMOVE REAR UPPER CONSOLE PANEL SUB-ASSEMBLY


B132348
  1. Disengage the 3 clips and 3 claws.

  1. Disconnect the connector and remove the rear upper console panel.



9. REMOVE CONSOLE BOX CARPET


    B132346
  1. Remove the console box carpet.



10. REMOVE REAR CONSOLE BOX ASSEMBLY


    B132349
  1. Disconnect the clamp.

  1. Remove the 2 bolts and 2 screws.

  1. Disengage the 4 claws and remove the rear console box.



11. ADJUST PARKING BRAKE LEVER TRAVEL


C116905E01
  1. Loosen the lock nut and turn the adjusting nut until the parking brake lever travel is corrected to within the specified range.

    Parking brake lever travel:
    6 to 9 clicks at 200 N (20 kgf, 45 lbf)

  1. Tighten the lock nut.

    Torque:
    5.4 N*m{ 55 kgf*cm , 48 in.*lbf }

  1. Operate the parking brake lever 3 to 4 times, and check the parking brake lever travel.

  1. Check whether the parking brake drags or not.

  1. When operating the parking brake lever, check that the brake warning light illuminates.

    Standard:
    Brake warning light always illuminates at the first click.



12. INSTALL REAR CONSOLE BOX ASSEMBLY


    B132349
  1. Engage the 4 claws and install the rear console box.

  1. Install the 2 bolts and 2 screws.

  1. Connect the clamp.



13. INSTALL CONSOLE BOX CARPET


    B132346
  1. Install the console box carpet.



14. INSTALL REAR UPPER CONSOLE PANEL SUB-ASSEMBLY


B132348
  1. Connect the connector.

  1. Engage the 3 clips and 3 claws and install the rear upper console panel.



15. INSTALL UPPER CONSOLE PANEL SUB-ASSEMBLY


B132347
  1. Engage the 5 clips and the claw and install the upper console panel.



16. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY (for Manual Transaxle)


17. INSTALL CENTER LOWER INSTRUMENT PANEL FINISH PANEL


B132316
  1. Engage the 2 claws and 2 clips and install the instrument panel finish panel.