Home › Brake › BRAKE SYSTEM (OTHER) › BRAKE PEDAL (for Sedan)

BRAKE PEDAL (for Sedan) > REMOVAL



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL


2. REMOVE CENTER LOWER INSTRUMENT PANEL FINISH PANEL


B132316
  1. Disengage the 2 claws and 2 clips and remove the instrument panel finish panel lower center.



3. REMOVE INSTRUMENT PANEL FINISH PANEL END LH



4. REMOVE INSTRUMENT PANEL FINISH PANEL END RH



5. REMOVE INSTRUMENT CLUSTER FINISH PANEL NO.1



6. REMOVE COMBINATION METER ASSEMBLY



7. SEPARATE FRONT DOOR OPENING TRIM WEATHERSTRIP RH



8. SEPARATE FRONT DOOR OPENING TRIM WEATHERSTRIP LH



9. REMOVE FRONT PILLAR GARNISH RH



10. REMOVE FRONT PILLAR GARNISH LH



11. REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY



12. REMOVE UPPER INSTRUMENT PANEL SUB-ASSEMBLY



13. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY



14. REMOVE COLUMN HOLE COVER SILENCER SHEET


    A116501
  1. Pull back the floor carpet, remove the 2 clips and remove the column hole cover silencer sheet.



15. REMOVE STEERING INTERMEDIATE SHAFT ASSEMBLY


    G028410E01
  1. Loosen bolt A.

  1. Place matchmarks on the steering intermediate assembly and steering gear assembly.

  1. Remove bolt B and detach the steering intermediate assembly from the steering gear assembly.

  1. Place matchmarks on the steering intermediate assembly and steering column assembly.

  1. Remove bolt C and detach the steering intermediate shaft assembly from the steering column assembly.



16. REMOVE STOP LIGHT SWITCH


C116877
  1. Disconnect the connector from the stop light switch.

  1. Disconnect the wire harness clamp from the pedal support.



    C116878
  1. Turn the stop light switch counterclockwise, and remove the stop light switch.



17. REMOVE STOP LIGHT SWITCH MOUNTING ADJUSTER


C116879
  1. Remove the stop light switch mounting adjuster from the pedal support.



18. SEPARATE BRAKE MASTER CYLINDER PUSH ROD CLEVIS


C116880
  1. Remove the brake pedal return spring.

  1. Remove the clip and the push rod pin and separate the push rod clevis from the brake pedal.



19. REMOVE BRAKE PEDAL SUPPORT


C116881
  1. Remove the 4 nuts and bolt and remove the pedal support.



20. REMOVE BRAKE PEDAL
  1. Remove the nut and brake pedal shaft and remove the brake pedal from the pedal support.



21. REMOVE BRAKE PEDAL BUSH
  1. Remove the 2 brake pedal bushes from the brake pedal.



22. REMOVE BRAKE PEDAL PAD
  1. Remove the brake pedal pad from the brake pedal.