Home › Drivetrain ยท AXLE AND DIFFERENTIAL › FRONT AXLE HUB BOLT (for Sedan)

FRONT AXLE HUB BOLT (for Sedan) > REPLACEMENT

for Preparation Click here



1. REMOVE FRONT WHEEL


2. SEPARATE FRONT DISC BRAKE CALIPER ASSEMBLY


C085618
  1. Remove the 2 bolts and separate the disc brake caliper from the steering knuckle.

    NOTICE:
    Hang the caliper using a piece of string or the equivalent.



3. REMOVE FRONT DISC


C108932E01
  1. Place matchmarks on the disc and axle hub and remove the disc.



4. REMOVE FRONT AXLE HUB BOLT


G031912E01
  1. Using SST and a screwdriver or the equivalent to hold the axle hub, remove the hub bolt.

    SST
    09628-10011  



5. INSTALL FRONT AXLE HUB BOLT


G031913E01
  1. Install the washer and the nut onto a new hub bolt, as shown in the illustration.

  1. Using a screwdriver or the equivalent to hold the axle hub, install the hub bolt by tightening the nut.



6. INSTALL FRONT DISC


C108932E02
  1. Align the matchmarks of the disc and axle hub and install the disc.
    Text in Illustration 
    *a
    Matchmark

    NOTICE:
    When replacing the disc, select the position that gives the minimum disc runout.



7. INSTALL FRONT DISC BRAKE CALIPER ASSEMBLY
  1. Install the disc brake caliper onto the steering knuckle.

    Torque:
    107 N*m{ 1089 kgf*cm , 79 ft.*lbf }



8. INSTALL FRONT WHEEL

Torque:
103 N*m{ 1,050 kgf*cm , 76 ft.*lbf }